Would prefer turning experience.  Setup and editing experience is required!

 

 

 

 

The laser operator will operate a Tanaka Fiber Laser and Bevel Laser.

 

 

Run CNC saw.  Must have good math skills to calculate angels.

Gather parts from fabrication and kit together for weld department.

175 or 350 ton brake press.  Must have experience choosing dies and blueprint reading.

 

 

 

 

 

 

 

 

Setup and burn with fuel gas bevel cutting tip.  Setup and burn structural shapes and 3 dimensional parts.

 

 

 

 

Performs complete layout inspection by measuring dimensions, such as length, height, and
distance between reference points, using precision instruments such as micrometers, calipers,
dial indicator, and CMM, to ensure product meets specifications
Locate reference point(s) on part and measure dimension such as angle, arc, and radii, using
combinations of aids, such as surface plate parallel bars, angle plates, gauge blocks, plug pins, V
blocks, sine bars, and precision measuring instruments such as height gage
Perform structural steel inspections, weld inspections, special inspection, and other related
inspections, and generate inspection reports as required
Perform all NDE inspections that the technician is qualified for per SNT-TC-1A standard. This
may include utilizing Liquid Penetrant Testing, Magnetic Particle Inspections, Ultrasonic Testing
and Visual Inspections

A minimum of one-year previous experience using computer and measuring instruments.
CMM operation and programming a plus.

Education and Experience
Technical Degree preferred but will consider work experience of lieu of degree
CWI Preferred with 2+ years of technical experience
Level II qualification in at least three Nondestructive testing methods (PT,MT,VT,UT)
Ability to read and interpret blueprints
Visual acuity to read directions and prints to inspect parts closely to ensure that they meet
standards
Excellent Communication Skills – both written and verbal
Intermediate level or higher computer skills
Valid Driver’s License – you will have to travel to vendor locations on some occasions

 

 

Gather parts from fabrication and kit together for weld department.

1. Looking for a CNC programmer for both Mill and Lathe.  Needs to have experience in some sort of programming software with Mastercam preferred.  Would need to have had machining experience before they became a programmer.  Person will also need to work on the floor if no work is needed in the office.  They need to understand how to fixture parts and have good knowledge of tooling.  Person will be working closely with machinists on floor so will need to have good people skills and be able to adjust on the fly to changing work conditions.  Need to understand programming and machining parts in 3D.  Most important is that the person has to have a good attitude and take the time to make the programs correct before the machinist gets it on the floor.  Pay is 22-28 per hour for a 1^st shift position normal week would be 40 hours 6-2:30 but will need to work more depending on volume of work and if something is needed for second shift.  Interviews will need to be after 2pm.

 

Looking for 1st and 2nd shift machinist with Haas experience.  Will look at full time or part time employees.  Waukesha county location!